The deadline for the receipt of contributions to the Proceedings of PAC'11 is
Described below are some basic requirements for the
preparation of contributions - more complete guidelines are provided in the text
of our templates, available at the
All contributions should be submitted via the Internet according to the guidelines to be published shortly. Authors are reminded that, since no contributions are accepted for publication only, any paper accepted for presentation, which is not presented by one of the authors at the conference, will be excluded from the proceedings.
Furthermore, the Scientific Program Committee reserves the right to refuse papers for publication which have not been properly presented in the poster sessions. Manuscripts of contributions to the proceedings (or enlargements of them) are not considered as posters and papers presented in this way will not be accepted for publication.
Authors are advised to use the
Templates and in case of difficulties they should consult the
JACoW electronic publication help pages. The templates contain styles which,
when applied, will automatically ensure correct typesetting and layout.
Papers for both contributed oral and poster presentation may be up to 3 pages
long and only invited oral presentations may be up to 5 pages.
See the templates for a typical implementation of the requirements.
Manuscripts should be prepared for one side of the paper and
The margins should be as follows:
|Margins||A4 paper||US Letter paper|
|Left||20 mm||20 mm|
|Right||20 mm||26 mm|
|Top||37 mm||19 mm|
|Bottom||19 mm||19 mm|
Authors should use only Times or Times New Roman (in roman, bold or italic) and Symbol fonts. All contributions should use 10pt fonts for the normal text.
The title should use 14pt bold uppercase letters and be centered on the page.
The names of the authors and their organization/affiliation and mailing address should be listed alphabetically in 10pt upper and lower case letters, grouped by affiliation. When there is more than one author, the submitting author's name should be listed first, followed by the other names in alphabetical order.
Section headings should use 12pt bold uppercase letters and be centered in
the column. They should NOT be numbered.
Widow and Orphan Control: All headings should appear next to the following text - there should never be a column break between a heading and the following paragraph.
Subsection headings should use 12 pt italic letters, be left aligned and
justified in the column. As for section headings, they should NOT be numbered.
Paragraphs should use 10pt font and be justified (touch each side) in the column. The beginning of each paragraph should be indented approximately 3 mm (0.13 in). The last line of a paragraph should not be printed by itself at the beginning of a column nor should the first line of a paragraph be printed by itself at the end of a column.
Place figures and tables as close to the place of their mention as possible.
Lettering in figures and tables should be large enough to reproduce clearly,
using only the approved fonts. Use of non-approved fonts in figures often leads
to problems when the files are processed and may even cause loss of information.
All figures and tables must be given sequential numbers (1, 2, 3, etc.) and have a caption placed below the figure or above the table being described.
A simple way to introduce figures into a Word document is to place them inside a table which has no borders. This can be achieved by doing the following: To insert a full width figure:
If a displayed equation needs a number, place it
flush with the right margin of the column.
All bibliographical and web references should be numbered and listed at the
end of the paper in a section called "References." When referring to a reference
in the text, place the corresponding reference number in square brackets. A URL
may be included as part of a reference, but its hyperlink should NOT be added.
See the templates for a typical example.
Acronyms should be defined the first time they appear.
DO NOT number pages. Page numbers will be added by the Editing Team when they produce the final proceedings.
Authors are strongly advised to use the template corresponding to the correct
version of WORD and not to transport the document across different platforms
e.g. MAC <-> PC or across different versions of WORD on the same platform.
Once all files are ready for submission, login to your PAC'11 Author Profile and
SPMS data will be used for the production of the table of contents and author index of the proceedings. Failure to enter all co-authors means they will be omitted from the author index.
See the guidelines for paper upload that will be published shortly.
|Print this page||last update: February 17, 2011
by Nick Franco