RHIC Configuration Manual

Accelerator Division Collider-Accelerator Department


RHIC Configuration Manual
Previous Revisions
	Facility Scope		Thomas Roser	Latest Revision
		Introduction		Nov. 2006
		Facility Scope		Nov. 2006
		The Collider Rings		Nov. 2006
		The Collider Scenario		Nov. 2006
	*Lattice and Beam Dynamics*		*Dejan Trbojevic*
		Arcs		Oct. 2004
		Insertions		Oct. 2004
		Chromatic Effects		Oct. 2004
		g_T-jump		Oct. 2004
		Lattice Correction Systems		Oct. 2004
	*MAGNET SYSTEM*		*Peter Wanderer*
		Overview		Feb. 2006
		Superconductor		Feb. 2006
		Standard Aperture Dipoles		Feb. 2006
		Standard Aperture Quadrupoles		Feb. 2006
		Sextupoles		Feb. 2006
		Trim Quadrupoles		Feb. 2006
		Standard Aperture Corrector Magnets		Feb. 2006
		Standard Aperture CQS Assemblies		Feb. 2006
		Large Aperture Correctors		Feb. 2006
		Insertion Quadrupoles		Feb. 2006
		Large Aperture CQ Assemblies		Feb. 2006
		100 mm Aperture Insertion Dipole		Feb. 2006
		180 mm Insertion Dipole		Feb. 2006
		Helical Dipoles		Feb. 2006
		References		Feb. 2006
	*MAGNET ELECTRICAL SYSTEM*		*Jon Sandberg & Don Bruno*
		Power Supplies		Feb. 2006
		Magnet Bus		Feb. 2006
		Cable Tray System		Feb. 2006
		Quench Protection System		Feb. 2006
		Insertion Power Supply Systems		Feb. 2006
		Correction Magnet Power Supply Systems		Feb. 2006
		Power Supply Connections of Corrector Magnets		Feb. 2006
		Main Magnet Power Supplies		Feb. 2006
		Insertion Power Supplies		Feb. 2006
		RHIC Bipolar Corrector Power Supplies		Feb. 2006
		Sextupole Power Supplies		Feb. 2006
		Siberian Snake Power Supplies		Feb. 2006
		Quench Protection System		Feb. 2006
		Quench Detection System		Feb. 2006
		Energy Extraction System		Feb. 2006
		Quench Link		Feb. 2006
	*CRYOGENIC SYSTEM*		*Anthony Nicoletti*
		Introduction		Nov. 2005
		Heat Load of Magnets and Refrigeration Distribution System		Nov. 2005
		Refrigerator Cycle Calculations		Nov. 2005
		Pressure Ratings		Nov. 2005
		Pressure Drop of Magnets and Distribution System		Nov. 2005
		Helium Inventory for RHIC		Nov. 2005
		System Thermal Mass and Cooldown/Warmup Time Estimates		Nov. 2005
		System Components		Nov. 2005
		Cryogenic Control System		Nov. 2005
	*VACUUM SYSTEM*		*Dick Hseuh*
		Beam Vacuum		Oct. 2004
		System Configuration		Oct. 2004
		Instrumentation and Control System		Oct. 2004
		Experimental Vacuum Systems		Oct. 2004
	*BEAM TRANSFER AND INJECTION*		*Wolfram Fischer*
		Principle Characteristics and Parameters		Oct. 2004
		Equipment		Oct. 2004
		Operation		Oct. 2004
		Tolerances		Oct. 2004
	*BEAM DUMP SYSTEM*		*Leif Ahrens*
		System Introduction		Oct. 2004
		Kicker Magnet Requirements and Design		Oct. 2004
		Pulser and PFN Requirements and Design		Oct. 2004
		Beam Absorber		Oct. 2004
		Beam Instrumentation		Oct. 2004
	RF SYSTEMS		Mike Brennan
		General Considerations
		The Acceleration rf Cavity and Driver System
		The Storage rf Cavity
		The Wideband Cavity
		Beam Loading Considerations
	*BEAM INSTRUMENTATION*		*Thomas Russo*
		Beam Position and Closed Orbit Measurement
		Beam Current Monitors
		Beam Loss Monitor System
		Transverse Damper/Tune Measurement System
		Beam Profile Monitor
		Luminosity Monitor - Zero Degree Calorimeter
	*CONTROL SYSTEM*		*Don Barton*
		System Requirements
		System Architecture
		Front-End Systems
		Network and Links
		Control Center
		Software
	*CONVENTIONAL FACILITIES*		Martin Fallier & Al pendzick
		Ring Tunnel and Experimental Halls		Nov. 2004
		Shielding		Nov. 2004
	*COLLIDER INSTALLATION*		*Gary McIntyre*
		Ring Element Nomenclature System		Oct. 2004
		Tunnel Survey and Magnet Alignment		Oct. 2004
		Tunnel Equipment Clear Zone		Oct. 2004
		Warm Space Components Allocations		Oct. 2004
	*SAFETY SYSTEMS*		*Neville Williams*
		Personnel Safety Systems		Nov. 2004
	*POLARIZED PROTONS*		*Waldo MacKay*
		Polarized Proton Collider at RHIC		Oct. 2004
		Polarized Proton Collider at RHIC
	*SYSTEMS INTEGRATION*		*Jon Sandberg*
		Design Requirements Relating to Power Line Perturbation